Beck DB240 Bedienungsanleitung PDF herunterladen (Seite 8)

IPC@CHIP

DK241

Getting Started V1.02

Hint: By the way, if you double-click on the title line of a ONE-Workbench window, it will be

maximized. If you double-click again, it will be restored to its original size.

You may now use the commands of the @CHIP-RTOS-PPC shell in the terminal window. The

command DIR will, for example, display a list of the files shipped on your IPC@CHIP

internal

drive.

2.4.2 Setting up the Ethernet communication

Network communication is based on the TCP/IP protocol family. To be able to operate in a

TCP/IP network, your IPC@CHIP

needs to be assigned a valid and unambiguous IP address

and network mask. If you cannot figure out a proper IP address and network mask for your

IPC@CHIP

, please consult your network administrator.

There are two ways of assigning an IP address to your IPC@CHIP

SC243. You may either

configure it by hand or you may use DHCP to automatically assign IP settings. Of course you

will need a DHCP server to achieve the latter.

The default configuration for the IPC@CHIP

is using DHCP since this will ensure that the

IPC@CHIP

adapts to an existing network if this network provides a DHCP server. If your

network doesn‟t have a DHCP server, the IPC@CHIP

will not disturb the operation of your

network.

If you have a regular local network with several clients, connect the DB240‟s Ethernet interface

to your Ethernet hub or switch using the enclosed twisted pair patch cable (gray) and go on to

either section X 2.4.2.1X or X 2.4.2.2, depending on how you‟d like to assign IP settings to your

IPC@CHIP

If you‟re not connected to a network but want to connect the DB240 directly to your PC, you

have to use the enclosed cross-over twisted pair Ethernet cable (red) to plug the DB240‟s

Ethernet interface to your PC‟s Ethernet interface. Then go on to section X2.4.2.2X.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Keine Kommentare

Beck DB240 Bedienungsanleitung Seite 8